No DIY skills whatsoever are needed to fit STOPG-P

You should be able to finish an average room in under an hour

There’s no need to take furniture or rugs out of the room, simply move them to one side temporarily as required

If dirt and dust have accumulated in the gap, use an old credit card or something similar to loosen it and then vacuum. For safety reasons, avoid inserting metal implements through floorboard gaps

Remove roll of STOPG-P from box, cut off corner of plastic bag, pull out sufficient STOPG-P to fit length of gap and cut to size with scissors

Fold STOPG-P lengthwise and push into gap until it rests on joists below (Floors are supported on floor joists approximately 400mm apart, at right angle to floorboards)

Rearrange furniture

Make nice cup of tea

                  *STOPG-P is designed to exclude draught through gaps between 1–8 mm wide,

         especially gaps between square-edged wooden floorboards. The gap must be

          10mm or more deep so that the seal can be pushed out of sight. This makes it

  unsuitable for tongue and groove boards. Exceptionally, the seal can be

trimmmed with scissors to fit shallower gaps.

       GENERAL USE

for example between floor and skirting; window gaps; etc
  

           Invented, developed, manufactured and packaged in Great Britain